Sail E0 Webinar

MCQs

Total Questions : 903 | Page 1 of 91 pages
Question 1. For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as (where p is basic wind pressure)
  1.    zero
  2.    ±0.2p
  3.    ± 0.5 p
  4.    ±0.7p
 Discuss Question
Answer: Option B. -> ±0.2p
Question 2. The sway bracing is designed to transfer
  1.    2Vi % of the top panel wind load to bottom bracing
  2.    10% of the top panel wind load to bottom bracing
  3.    25% of the top panel wind load to bottom bracing
  4.    50% of the top panel wind load to bottom bracing
 Discuss Question
Answer: Option D. -> 50% of the top panel wind load to bottom bracing
Question 3. The relation between intensity of wind pressure p and velocity of wind V is taken as
  1.    pa V
  2.    paV2
  3.    p a (1/V)
  4.    paV”2
 Discuss Question
Answer: Option B. -> paV2
Question 4. The internal pressure coefficient on walls for buildings with large permeability is taken as
  1.    ± 0.2
  2.    ±0.5
  3.    ± 0.7
  4.    0
 Discuss Question
Answer: Option C. -> ± 0.7
Question 5. If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be
  1.    40mm
  2.    60mm
  3.    80mm
  4.    100mm
 Discuss Question
Answer: Option B. -> 60mm
Question 6. Steel tanks are mainly designed for
  1.    weight of tank
  2.    wind pressure
  3.    water pressure
  4.    earthquake forces
 Discuss Question
Answer: Option C. -> water pressure
Question 7. The minimum thickness of plates in a steel stack should be
  1.    4 mm
  2.    5 mm
  3.    6 mm
  4.    8 mm
 Discuss Question
Answer: Option C. -> 6 mm
Question 8. The shape factor of an isosceles triangle for bending about the axis parallel to the base is:
  1.    1.5
  2.    1.7
  3.    2.0
  4.    2.34
 Discuss Question
Answer: Option D. -> 2.34
Question 9. Which of the following conditions is to be satisfied both in elastic and plastic analysis ?
  1.    equilibrium condition
  2.    yield condition
  3.    plastic moment condition
  4.    mechanism condition
 Discuss Question
Answer: Option A. -> equilibrium condition
Question 10. Bending compressive and tensile stresses respectively are calculated based on
  1.    net area and gross area
  2.    gross area and net area
  3.    net area in both cases
  4.    gross area in both cases
 Discuss Question
Answer: Option B. -> gross area and net area

Latest Videos

Latest Test Papers